6/12/2009
8 of 20
PRODUCT HOLDING CABINET
EQUIPMENT
MANUAL
U.S. Patent 6175099, 6262394
Other U.S. and Foreign Patents Pending
DUKE MANUFACTURING CO.
TOLL FREE 800-735-DUKE (3853)
314-231-1130
Installation Instructions
1. Place warmer module onto stable surface.
2. Attach power supply cord to IEC 60320 C20
using approved cordset.
3. Follow instructions in the Operators Manual
PERIODIC MAINTENANCE, CHECKLIST AND
CLEANING GUIDE.
Stacking Units
The FWM3-24 Product Holding Cabinet is designed to allow limited stacking capabilities. This section outlines
how to safely stack the holding cabinet.
1 Step
Remove the base pan from all holding cabinets, except for
bottom unit, that are to be stacked. The pan is held in
place by two screws on the bottom of the unit.
Place bottom unit into position then stack the next unit on top. The top
of the lower holding cabinet rests inside of the base of the upper unit.
WARNING!
TIP HAZARD! Do not stack FWM3-42
units. Do not exceed 3 holding cabinets
per stack. Do not place holding cabinet
stacks on surfaces that may easily tip over.
2 Step
Risk of fire or electric shock. Replace cord with one of the following Duke
cordsets only:
P/N 156533 Cordset, NEMA 5-15P, 120 V
P/N 156811 Cordset, NEMA 5-20P, 120 V Canadian FWM3-24 & FWM3-42 units
P/N 156421 Cordset, NEMA 6-15P, 208/240 V
P/N 156400 Cordset, 230 V CE
The proper way to connect the power cord is to loosen the screw,
push the cord fully into the holder and then retighten the screw.
To Next Page
Loading...
