Duke ReadyFlex RFHU-35M - RFHU Operating Instructions - Offline Configuration; Offline RFHU Configurator; Download PHU Configuration File

RFHU - Multiuse Operator’s Manual
22
RFHU OPERATING INSTRUCTIONS  Continued
For the user’s Account an “oine recipe set” will
always be available to the user. This information
will be saved and be readily available if a USB le is
required to be created.
The RFHU Congurator is available for well
programming.
As the unit is not connected the RFHU congura-
tion, for example 2x2, 2x4 will not be automatically
detected.
Instead a list of available congurations will be
available for programming.
NOTE:
H1 - Bottom Heat Only Unit Congurations
H2 - Top and Bottom Heat Unit Congurations
You must select the proper conguration for your
unit.
When a selected PHU conguration is selected the
appropriate programming grid will appear. For
example a 2x4 will appear as:
These include:
This can then be programmed in the same way as
the online RFHU. For example:
When nished select “DOWNLOAD PHU CONFIGU-
RATION FILE” option. This will create a RFHU “RCP”
le which contains both the recipe list and well
mapping settings.
This le can then be copied to the “root” directory of
a USB ash drive.
Plug this same USB drive into the USB port on an
RFHU and if the conguration is correct both the
recipe list and well programming will be uploaded
on the unit itself. A conrmation message will ap-
pear on the RFHU display when a new recipe set has
been successfully loaded.