Maintenance Manual for DUKE TSC Proofer
Oven with Touch Screen Controls
20
Figure: Halogen Lamp Assembly
Turn counter-clockwise.
Remove bulb cover.
Lamp Holder
Assy.
G4 12V
Flat Lens
58mm
(502794)
Gasket -
Lens 58mm
(502795)
10W (Max.) Lamp
12V Halogen
G-4 (Bi-Pin)
(512495)
2. Unlatch the bottom clip.
DO NOT TOUCH LIGHT BULBS
WITH BARE HANDS AS OIL/
FINGERPRINTS WILL SHORTEN THE
LIFE OF THE BULB. USE A CLEAN
GLOVE OR CLOTH TO HANDLE
BULBS.
Figure: Door Clipped Together
After Cleaning
Figure: Unlatch Bottom Clip
3. Cool-Touch Door bottom easily swings
open for cleaning.
Figure: Door Swings Open for Cleaning
4. Cool-Touch inner door is easily
clipped to the outer door by squeezing
them together.
1. Turn the Proofer Oven OFF and allow to
cool.
2. Remove the light lens and gasket by
turning it counter clockwise.
3. Remove the burned out bulb.
4. Using clean gloves or a cloth, install the
new lamp bulb (Halogen Lamp G4, 12
Volts, 10 Watt Maximum) into the lamp
holder.
5. Replace light lens and gasket ensuring it
is fully seated and tightened or leaks will
occur.
BULB MOUNTING DETAILS
To Next Page
Loading...
