SAMPLE SETTINGS
The settings below are great starting points. The settings for the Resonance Switch only
apply when the pedal is connected directly to your instrument.
Clean, buffered boost
This setting will give a transparent boost to your signal to drive
the rest of your pedalboard with greater signal headroom and
no loss of high-end, or use at the end of your pedal chain to
drive long cable runs back to your amp.
Fattened Strat
Setting the Resonance Switch to the “1” position will shift
the resonant peak of a single-coil pickup down,
thickening up your tone. Putting the Gain control up to
the 12 o’clock position will let you drive the front-end of the
amp for more grit. This setting really lets the intensity of your
playing come through, staying clean until you dig in and bring
out the sweet harmonics of your amp.
Maximum Beef
This setting, with the Resonance Switch on “2” and the Gain
control all the way up, gives a single-coil the fatness of a
high-output humbucker along with the full push of your
amp’s preamp stage, resulting in a meaty, saturated tone.
Great for beefing up your solos!
To Next Page
Loading...