7 … 96
Printed in Germany • Edition 04.18 • Nr. 271 958
The target group of this manual is quali ed personnel of
the gas safety and regulating technology, skilled per-
sonnel or the persons instructed by them.
Due to their specialist training, knowledge and experience
and knowledge of standard regulations, they are capable
of evaluating the work assigned to them and recognising
possible dangers. Only they are permitted to carry out as-
sembly, commissioning, settings and maintenance on the
devices in compliance with the recognised rules for occupa-
tional safety.
Instruction manual
MPA 41xx PF
2. Warnings
Never carry out work as long as gas
pressure or voltage is applied. Avoid
open re. Please observe public regula-
tions.
The device must be protected from
vibrations and
mechanical impacts.
All adjustments and settings should
only be performed in accordance with
the instruction manuals of the connect-
ed machines.
The recognised occupational safety
rules and accident prevention regula-
tions must be observed and, if neces-
sary, personal protective measures
must be taken.
Connected line systems must be free
from dirt and contamination.
Hang this instruction manual in a readily visible place
inside the installation room! Do not carry out any
work until you have read the safety instructions of this
instruction manual.
The device may only be operated in
compliance with the operating condi-
tions stated on the type plate.
Prior to assembly, the device must be
inspected for transport damage.
The device must not be used in areas
with increased seismic risk.
Protection from environmental impacts
and weather conditions (corrosion, rain,
snow, icing, humidity (e.g. by conden-
sation), mould, UV radiation, harmful
insects, poisonous, corrosive solutions/
liquids (e.g. cutting and cooling uids
),
must be guaranteed. Depending on the
installation site, it may be necessary to
take protective measures.
The device must not be exposed to
open re. Protection against lightning
strikes must be guaranteed.
2.1 General warnings
1. Target group
Explanation of the symbols
1, 2, 3,... = Order of
action
• = Instruction
GB
To Next Page
Loading...
Need help?
General