DUOTTS F26 - Integral Body Installation Guide

INSTALLATION OF INTEGRAL BODY
1. Adjust the Stem to the
front and lock the screws
with an Allen key. Use an
Allen key to remove 4 bolts.
2. Attach the handlebar to
the stem connection, and
thread in the bolts.
3. Remove the front fork
protective rod and brake
protective pad.
4. Inflate the front wheel
slowly to prevent the tire
from bulging out on both
sides.
5. Place the gasket as
shown in the figure.
6. Front fork alignment
motor shaft installation.
7. Note: Align the disc
with the brake.
8. Use a wrench to tighten
the screws.
9. Install the front lights
and front fenders.
06