DUPLEX JSP
9. BEFORE CALLING FOR SERVICE
Machine does not produce steam
Make sure plug (21) is well inserted and that
and vacuum does not work.
there is main power to the socket outlets.
The red "low water" indicator (15)
All the water from the water tank (9) has been
Refill the water tank (9) with clean water.
There is no injection of detergent.
All the detergent from the detergent tank (8)
Control the level in the detergent tank (8) by lifting
the vacuum drum (4). if necessary, refill the
detergent tank (8) as described in the
Suction power is missing.
Lack of power to the vacuum
A. Make sure the switch (2) is on and the
plug (7) is well inserted
B. The vacuum tube is obstructed.
B. Clean tube and accessory used.
C. The vacuum drum (4) is full of water.
C. Empty the vacuum drum (4)
Check the wear of the o-ring.
Clean and lubricate the o-ring with grease.
connections of the accessories.
if necessary, replace with one spare supplied.
Boiler has not reached the
operational pressure (green light
Switch on the steam command
B. Steam command switches (36-37)
Use the steam command switch (34) to
Steam command switch (34) has not
Drops of water come out of the
At beginning of work water condenses in the
After a few minutes of use this problem will
tubes and accessories due to the difference in
If it continues, proceed to the cleaning of the
Noise inside the generator
The boiler getting cold, after about 6-7 hours
Wait the pressure stabilization (about 2-3
creates an internal depression which, at each
minutes), the noise disappears.
ignition, provokes some vibrations.
Accessories do not fit perfectly.
There is dirt build up in the joints and
Clean and lubricate the joints.
lock/release latches (40).
To Next Page
Loading...