DURA-BILT Dura-Breeze User Manual

Dura-Breeze
Portable RV Screen Room
DBSR-08
Installation Instructions
Read the instructions before starting the job. They explain the steps required
to produce a fi nished product that will meet factory specifi cations.
All references to “Left” and “Right” are while facing the home.
Check the material received.
Match your shipment with the Bill of Materials.
If there is a shortage or wrong material,
call Dealer Service immediately.
Safety is important!
Wear Safety Glasses and Work Gloves.
Follow all safety practices while assembling
and installing this product.
Dura-Bilt Products, Inc. P.O. Box 188 Wellsburg, N.Y. 14894
Dealer Service 570-596-2000 E-Mail info@durabilt.com
DURA-BILT RESERVES THE RIGHT TO CHANGE DESIGN AND/OR SPECIFICATIONS WITHOUT NOTICE.

DURA-BILT Dura-Breeze Specifications

General

Brand	DURA-BILT
Model	Dura-Breeze
Category	Garden Houses
Language	English

Summary

General Information

Deck Leveling and Preparation

Ensuring the deck is level and preparing concrete surfaces for installation.

Post Spacing and Placement

Proper spacing and plumb alignment of awning posts for screen wall installation.

Corner Post Offset

Details on the offset for corner posts to ensure side wall panel clearance.

Foam Tape Installation

Instructions for applying dark gray foam tape to the front header and post track.

Installing Front Wall Panels

Panel Placement and Awning Adjustment

Locating, positioning, and adjusting the awning for front wall panels.

Trim Cover and Panel Securing

Installing trim covers and securing panels with bolts and wing nuts.

Installing Side Walls Panels

Corner Marking and Wall Channel

Marking corners with plumb lines and attaching the RV wall channel.

First Side Panel Alignment

Aligning the first side panel with chalk lines and awning edge.

Spacer Panel Preparation and Installation

Measuring, cutting, and installing spacer panels with U channel and joiner.

Installing Center Post and Gable Panels

Center Post Placement and Securing

Positioning, plumbing, and securing the center post to the awning structure.

Post Anchor and Trim Cover Installation

Securing post anchors and attaching trim covers at panel joints.

Gable Panel Cutting

Cutting the gable panel to match the roof pitch based on measurements.

Gable Panel Installation

Installing the gable panel top cap, joiner trim, and seating the roof.

Install Door Hardware and Threshold

Door Handle and Closer Bracket

Installing the door handle and door closer bracket on the door header.

Threshold Installation

Cutting and installing the door threshold, with optional lag shields.

Completing the Installation

Bug Prevention Sealing

Using foam tape to seal cavities and prevent insects from entering the screen room.