Duraflo 60PRO130 - WeatherPRO Upward Venting Design; Cold Impact Tested Material; UV Protection and Material Quality

- 3 -
Injection molded from pure, high grade polypropylene with premium UV inhibitor additives
that blocks harmful UV Rays.
• Over 15 years of accelerated
weathering testing
• Customized UV inhibitor package in all
molded products
• All colours contain UV inhibitors
• CSA evaluated
Evaluated and passed based on
the following criteria:
• ASTM G 155 Accelerated Weathering
• ASTM D 638 Tensile Strength Dierence
• ASTM D 2843 Smoke Density Rating
• ASTM D 635 Rate of Burning
Material & UV Protection
Material - Cold Impact Tested
WeatherPRO® Upward Venting
The solid sidewalls and upward venting design behind the WeatherPRO® vents have been engineered to increase
weather protection while improving ventilation in high wind areas. The solid sidewalls work in part with the interior
baes, providing the rst line of defense against driving rain and snow. The solid sidewalls also act to push wind up
and over the cap of the vent, as opposed to under, like a traditional roof vent. This airow over the cap of the vent
creates negative pressure to draw air from the attic.
The WeatherPRO® line of vents are manufactured from all virgin polypropylene allowing them to withstand the most
extreme climates. The material used in manufacturing the WeatherPRO® Series is cold impact tested at -40 degrees.
The material remains functional, exible and resilient to damage even when installed with a nail gun.
UV Protected
Polypropylene
0.06”
(1.52 mm)
0.009”
(0.229 mm)
UV Rays are
blocked
after only
.009”
(0.229 mm)
Interior
bae
shield
Interior bae shield
Interior bae shield
Interior bae shields