DURAG D-ISC 100 2 Series User Manual

7 | Main menu
D-ISC 100 x xx2
81
7.2 [User mode] menu 1
Specific parameter
Menu: 1
Status: S1.3:Normal measurement
Menu
\\
User mode
Specific parameter
Display setup
System setup
Channel setup
Login / Logout
:
:
:
:
:
:
:
About D-ISC 100
E
Fig.7.3: Selecting the user mode
The clarify of the information shown in the display is attuned to
the user for the tasks in question.
Go to
["User mode"] in the main menu:
D‑ISC100 menu path:
Standard display (e.g. S1.1) User mode (menu1)
=User mode MENU1
Specific parameter
Menu: 1.1
Status: S1.3:Normal measurement
User mode
Expert mode
:
E
Basic mode
User mode
Fig.7.4: User mode
1.
[
Basic mode].
In this mode, no entries are displayed that allow for settings to
be changed. Tests can be carried out on the connected
sensors (contamination test, linearity check etc.) and the
measured values and messages can be read out.
2.
[
Expert mode]. In this mode, all menus are displayed in full.
The current user mode is shown in the status bar at the bottom
right.
 stands for Expert mode (Fig.7.4),


stands for Basic mode.
7.3 Login/logout menu 5
7.3.1 [Login/logout] menu 5
The Login/Logout menu (see also Section 7.3.2 General in-
formation on the PIN lock [}81]) can be found underneath the
Channel setup menu.
D‑ISC100 menu path:
Standard display (e.g. S1.1) User mode (menu1) Login/
Logout (menu5)
Login MENU 5.1
=Login
7.3.2 General information on the PIN lock
Access to essential settings for the measuring system can be
protected with a PIN lock.
We recommend first starting-up and configuring the entire meas-
uring system (incl. sensors and modules) before PIN protection
is introduced.
The protection is then propagated by the Universal control unit to
the sensors and modules.

DURAG D-ISC 100 2 Series Specifications

General

Brand	DURAG
Model	D-ISC 100 2 Series
Category	Control Unit
Language	English