32
EN
COMMISSIONING AND TEST
1 Test the device with a metal sample before searching outside, e.g. with:
• Iron nail
• 10/20/50 Euro cent coin (copper)
• 1 or 2 Euro coin (copper / nickel)
• Silver coin
2 Carefully place the detector on a wooden or plastic table with the search
coil protruding at least 30 cm beyond the end. Hold the test objects as
centrally as possible over the search coil. Important: Keep the detector
away from other power sources. Please remove all personal metallic
objects before testing as they may interfere with detection.
3 After pressing the POWER button, the detector will beep twice and the
screen will light up. As soon as the detector is ready, it will resume the
mode it was in before it was last turned off.
To Next Page
Loading...
Need help?
General
