40
EN
• If both the signal frequency and the signal strength show no obvious
change, the ground balance is already set.
• If there is an obvious change when approaching the ground, then you
need to adjust the ground balance.
• Raise the search coil again and turn the ground balance knob 15
degrees clockwise.
• Press the PINPOINT button again and bring the coil to about 1.5 cm
above the ground.
• If there is an obvious change again, repeat the process until the ground
balance is set and there is no major change when lowering.
• Adjust the ground balance slowly so as not to over-adjust and reduce
the sensitivity.
• Note: In heavily mineralized or magnetic soils, it may be difcult to
achieve the correct ground balance.
(8) Depth and destination
• The ve modes selected with the MODE button are all motion modes.
They indicate a rough metal type, depth and location.
• When the position and type of metal of the object are detected, a
repeated beep will sound. If this is not the case, it could be an incorrect
target, a waste metal or a heavily oxidized object.
• Once a metal object has been found, the upper scale arrow will
indicate the type of metal. The results will be more accurate in neutral
soil than in heavily mineralized soil.
To Next Page
Loading...
Need help?
General
