Adjust eccentric
The eccentric 7 has to be adjusted in such a way that the axes of the
two markings 9 and 10 are on a similar level.
–
Loosen screw 8.
–
Turn eccentric in such a way that the axes of the two markings 9
and 10 are intersecting.
–
Tighten screw 8.
2.3.2 Adjust the 2nd stitch length (subclass 367-170315 and 367-180315)
Only adjust the 2nd stitch length after the stitch regulator gear has
been adjusted.
–
Turn the the upper setting wheel to “4”.
–
Loosen the screw 13 and remove the setting wheel 12.
–
Turn cautiously the shaft 14 c lockwise as far as it will go using a
10 mm open-end wrench.
–
Twist the scale 11 to “4”.
–
Put the setting wheel 12 back again and fix it using the screw 13.
Caution: Danger of injury !
Switch off main switch.
Set the stitch adjustment basic setting only when the sewing machine
is switched off.
10
7 10 9 8
11 12 13
14
11
To Next Page
Loading...
