2.13.3 Armature of the thread trimmer magnet
Caution: Danger of injury !
Switch off main switch.
Check and adjust the thread trimmer magnet only when the sewing
machine is switched off.
Standard checking
In resting position of the magnet there should be a distance of
0.2 to 0.3 mm between roller 6 and the highest point of the control
cam 5.
–
Shifttierod7withblock4totheleftasfarasitwillgo.
–
Check distance between roller 6 and control cam 5 with a feeler
gauge.
Correction
–
Loosen nut 2.
–
Twist armature 1 in the coupling piece 3.
–
Tighten nut 2.
–
Check adjustment and correct, if necessary.
40
7654321
To Next Page
Loading...
