DURKOPP ADLER 367 - Check Adjustment of Potentiometer

2.14.3 Check adjustment of potentiometer
–
Hold key “P” pressed down and switch on main switch.
–
Open the technician level.
(see Installation Instructions, Part 2 of the Instuction Manual)
–
Select parameter “F-188”.
–
Press key “E”.
The current Speedomat step and the c orresponding speed
limitation are indicated.
–
Set hand lever 1 (on 367-170115 and 367-180115) or the setting
wheels 2 (on 367-170315 and 367-180315) to the “low est stroke”.
Speedomat step “06” must be displayed.
–
Set hand lever 1 (on 367-170115 and 367-180115) or the setting
wheels 2 (on 367-170315 and 367-180315) to the “maximum
stroke”. Speedomat step “21” must be displayed.
The speed display shows “EEEE”.
Hint:
If the Speedomat steps “06” and “21” are not achieved, the
potentiometer has to be readjusted.
44
112