2.15 Oil lubrication
Caution: Danger of injury !
Oil can cause skin eruption.
Avoid a longer contact with the skin.
Wash yourself thoroughly after a contact.
ATTENTION !
The handling and disposal of mineral oils is subject to legal
regulations.
Deliver used oil to an authorized collecting station.
Conserve your environment.
Be careful not to spill any oil.
Oil the special sewing machine exclusively with the lubricating oil
DA-10 or an equivalent oil with the following specification:
–
Viscosity at 40° C: 10 mm²/s
–
Ignition point: 150° C
DA-10 can be bought at the sales points of DÜRKOPP ADLER AG
under the following parts number:
250 ml-Container: 9047 000011
1-Litre-Container: 9047 000012
2-Litre-Container: 9047 000013
5-Litre-Container: 9047 000014
Lubrication of the machine head
–
The machine head is equipped with a c entral oil wick lubrication.
Except the hook all bearings are supplied by the oil reservoir 1.
–
The oil level must not drop below the marking “MIN” .
–
Fill up oil up to the marking “MAX” through the drill-holes in the
inspection glass.
Lubrication of the hook
–
Tilt the machine head to the back.
–
The oil level must not drop below the marking “MIN” .
–
Fill oil reservoir 2 with oil through plug 3.
Hint:
The necessary oil quantity for the correct lubrication of the hook has
been adjusted by the manufacturer.
45
GB
1
32
To Next Page
Loading...
