16. Adjusting the optional equipment
16.1 Downholder and pocket bag clamp
The fullness in the pocket opening area caused by darts is
smoothened and safely held by means of the device (order number
0745 597514).
It consists of the following components:
Downholder 3
Clamping plate 2 for pocket bag parts
Caution: Danger of injury !
Switch off the main switch.
Check and adjust the downholder and the pocket bag clamp
only with the main switch turned off.
Standard
The downholder 3 should be aligned in such a way that it lowers close
to the folder (on the right and on the left r espectively) as well as to the
frontintheareaofsewingstart.
Adjusting the clamping plate 2
The clamping plate 2 is held by a magnet.
Adjust the clamping force by means of the magnet.
The adjusting screw is located underneath the table top.
Adjusting the dow nholder 3
Loosen the screws 5 at the clamping c ollar 6.
Adjust the height of the downholder 3.
When the pedal is actuated, the extended piston rod should just
touch the fabric sliding sheet.
Align the downholder 3 to the back ( in machine head direction).
The piston rod should hold the hind trousers part clamped, not the
pocket bag underneath.
Tighten the screws 5 at the clamping c ollar 6.
Regulate the lowering speed of the downholder 3 by means of the
butterfly valves 4 and 7.
The lowering motion should be rapid, but not abrupt.
142
231 47 6 5
To Next Page
Loading...
