Switching the flap feed on/off (versions B and F only)
Entry: on/off
Mode 1
Flap feeders swivel out.
Mode 2
Flap feeders remain swivelled in.
Sewing patterned or plain material (versions “D” and “F” only)
Patterned material
Plain material
Switching the piping blade on/off (versions B and F only)
Entry:
on/off
Cutting depth at the seam beginning
Cutting depth at the seam end
Selecting pedal mode
Two different variants of the insertion process with vacuum and / or
holder can be selected.
Pedal mode 1
In this mode the insertion process is carried out
by pressing and holding down the left pedal while operating
the right pedal.
Pedal mode 2
For insertion, the pedal must be brought to its initial
position, between the steps.
Pedal mode 3
The clamp goes in sewing position after actuating
the pedal.
32
To Next Page
Loading...
