6.2 Position of the needle bar wing in feed direction
Caution: Danger of injury !
Switch off main switch.
Check and adjust position of needle bar wing in feed direction only
when sewing machine is switched off.
Standard checking
At stitch length "0" the needle must stick in the centre of the needle
hole of the feed-dog.
If the adjustment is correct, the distance between the middle of the
needle and the front edge of throat plate 1 must be 24 mm.
--
Set stitch length "0".
Turn button counter-clockwise as far as it will go.
--
Move needle in position "down" by handwheel.
--
Check distance between needle and front edge of throat plate 1.
Correction
--
Screw off arm cover.
--
Loosen clamping screw 3 at lever 4.
--
Twist needle bar wing 2 until the needle is centric above the
needle hole of the feed-dog.
--
Tighten clamping screw 3.
2
3
4
24 mm
1
2
28
To Next Page
Loading...
