EasyManua.ls Logo

Duronic HS90 - Page 8

Duronic HS90
95 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8
Ensure that the iron is switched off and unplugged from the electrical
mains socket and fully cooled down before storing away.
Do not use any attachments which are not listed in this manual.
Always hold the iron by the handle. Keep the hot soleplate away from
body parts and heat-sensitive objects.
Do not turn the iron upside down; there may be hot water in the water
tank.
Do not leave water in the water tank when the iron is not in use - this can
corrode and damage the soleplate.
Keep the iron well away from surfaces and objects that can be damaged
by heat.
Ensure there is adequate space to operate the iron.
When not ironing, place the iron down onto the iron base, on a level
surface.
When ironing garments, use this iron only with a purpose-built ironing
board, on a at even surface.
Observe all of the ironing instructions and ironing temperature dot settings
given by the garment manufacturer. These guidelines are normally on the
label/s inside the garment.
Always ensure the water lling does not exceed the MAX mark.
Always switch off and unplug the iron when relling the water tank.
Do not ll the water tank with hot water or corrosive cleaning agents which
could cause damage to the iron.
Do not iron buttons or fasteners. This could damage the iron soleplate.