9
How to Use
1. Open the transparent lid, take out the ice basket and add water to the
water tank. The water should not exceed the MAX mark.
Use either cold or room-temperature water to ll the tank. Do not ll the
tank with hot water.
If the water exceeds the MAX mark, you will need to drain a little water
away. You do this by opening the bottom drain plug and releasing some
water.
2. Put the ice basket back into the machine and close the lid.
3. Plug in the machine and switch it on at the plug.
4. Press the power button to start the machine.
5. The machine will start to make ice cubes.
6. The ICE MAKING indicator light will light up stay on while the machine
works making the ice cubes.
7. When the ice basket is full, the machine will automatically stop. Remove
the ice cubes using the ice scoop. The machine will then restart and
ADD WATER:
• When the ADD WATER light turns red, it means that there is not enough
water left in the tank. You will need to add more water and then press the
power button to restart the machine.
ICE FULL:
• When the ice cubes ll up the ice basket and it reaches the maximum
capacity, the ICE FULL light will ash, and the machine will automatically
stop. You will then need to empty the ice basket using the ice scoop.
• Once the sensor inside the machine can detect the ice basket is empty,
the machine will restart automatically and continue making ice cubes.
Do not ll up the tank directly from a tap. When relling the water
tank, use a bottle or jug to pour water into it.
To Next Page
Loading...