Dust Right Separator - Dust Right Separator Troubleshooting; Too much dust and dirt is getting to your vacuums filter; Suction power seems lower than it should

6
Fig. 7
Shop vac
Separator
canister
Existing shop vacuum
hose or 2
1
⁄2" shop hose
FlexForm
™
hose
Fig. 8
7. Insert one end of your existing shop vacuum hose
in the open Separator port, and attach the other end
to your power tool dust port or a shop cleanup
handle/wand. Fig. 7.
Tip: Some shop vac hose fittings are slightly under
2
1
⁄4". In this case a couple wraps of tape will make
a tighter fit. Fig. 8.
8. For best results, do not fill past the fill line on the
Separator bucket. Fig. 9.
Dust Right
®
Separator Troubleshooting
Too much dust and dirt is getting to your
vacuum’s filter:
1. Small amounts of dust and fine dust will appear in
your vacuum’s filter. This is normal.
Tape
Shop vac hose