3 Tests and Diagnostics
3-50
[CONFIDENTIAL] dynabook PORTEGE A30-E/TECRA A30-G,-J/dynabook S Series Maintenance Manual (960-931)
3.17.3 Start and procedure
NOTE: If the test program doesn’t start, set Secure Boot to “Disabled” in Setup
program. As for Setup program, refer to 3.18 SETUP.
Step 1: Insert the USB memory created in the preparation step into the USB connector.
Step 2: Turn on the computer while pressing F12 to display the screen to select a boot
device.
Step 3: Choose USB device on the selection screen, and press Enter. The following message
will appear.
Battery Off Mode Setting tool
Vx.xx
Select test Menu
[1] Set – Battery Off Mode
[0] Exit
======================================
Input key of 1 or 0.
Step 4: When you press 1, the Battery Off mode should be set and display the result.
When the result shows “OK”, the Battery Off mode should be set surely. Press any key to
turn off the PC.
When the result shows “NG”, check the message.
Message Meaning
ERROR : Could not
execute this tool
because it is not a
Support model
The Battery Off mode program doesn’t support this
PC. The Program ends automatically.
Error Code : (0x8300)
The written data is incorrect.
Get Status : Disabled
(0x0000)
The setting was done but it but it has not affected.
Get Status : Error
(0x****)
Any other error occurs.
When any key is pressed, the program returns to Step
3. Retry to do this program several times. If NG
continues, end the program in Step 3 by pressing 0 key
and check the PC condition.
To Next Page
Loading...
