NO.
CONT.ON 33 PAGE NO.32
▼LAN Card information …IP address.
▼Progress status … Test progress by the progress bar.
3) Result Judgment
■ In case of PASS
“OK” is shown in the “Result” field on the “Diagnostics” dialog.
The pass count is shown in the “PASS” field.
■ In case of FAIL
“NG” is shown in the “Result” field on the “Diagnostics” dialog.
The pass and error count are shown in the “PASS” and “ERROR” fields respectively.
The detail of the error is recorded in the log file as follows.
Message Explanation Remarks
An IP address has not been assigned. IP address cannot be obtained. This error occurs when the test is
conducted with a LAN card to which IP is
not assigned.
WSAStartup failed: xx In-use API error
xx is the error code.
This is a message that is caused by an
error of Windows Socket API used in the
test.
failed to set recv timeout: xx In-use API error
xx is the error code.
failed to set send timeout: xx In-use API error
xx is the error code.
Invalid in-address: xx In-use API error
xx it the IP address
sendto failed: xx In-use API error
xx is the error code.
Wrote xx bytes Communication data size unmatched
xx is the reception size
recvfrom failed: xx In-use API error
xx is the error code.
timed out. Time out occurred.
4-2-7 CPU Test
1) Test contents
1-1) The test gets how many CPU cores exist on the PC.
1-2) The test executes ALU (Arithmetic Logic Unit) test and FPU (Floating Point Unit) test five times on the process.
1-3) The executes ALU test and FPU test five times on the each CPU core.
WPETD supports to test up to 8 cores.
If there is no problem with test 1-2 and 1-3, the test will get 1 Pass.
LAN Card information
Progress status
To Next Page
Loading...
