dynabook Satellite Pro L50-G - Page 151

4.177 LCD Panel 4 ReplacementProcedures
Satellite Pro L50-G / dynabookP*-C* MaintenanceManual 4-41
Installing the LCD Panel
NOTE: LCD/FL cable mustbe carefully peeledaway before disconnecting it from the
module.
Install the LCD Panelaccording to the following proceduresandFigures 4-19 and4-21.
Installing the LCD panel
Install the LCD Panelaccording to the following procedures.
1. Turn the LCD upsidedown.
2. Connect the LCD cable to the LCD module connector asFigure 4-21 shown.
3. Rip the Elastic tape on the LCD module cover.
4. Lift LCD panel top side up asFigure 4-20 shown, thenplace the LCD panel bottom
side down on the LCD module cover.
5. Check LCD cable below the LCD module cover latch asFigure 4-22 shown.
Figure 4-22 LCD cable below the LCD modulecover latch
CAUTION: Wheninstalling the LCD module,pleasefollow below instruction:
Whenplug in LCD/FL cable into LCD panel connector, needto plug horizontally.