dynabook Satellite Pro L50-G - SD Card Port; Procedure 1 Windows Application Test; Procedure 2 Connector Check and Replacement Check; Procedure1 Windows Application Test

2.17 SD Card Port 2 Troubleshooting
SatellitePro L50-G / dynabookP*-C* MaintenanceManual 2-25
2.17 SD card Port
                
             
            
 
Procedure1 Windows Application Test
Procedure 2 Connector Check and Replacement Check
Procedure 1 Windows Application Test
                
            
                 
    
Procedure 2 Connector Check and Replacement Check
              
               
           
      
Check1 Make sure IO Board FFCCablehasbeen firmly connected to the connector
on SystemBoard. Alsomake sure IO Board isfree of foreign matters.
            
               
            
Check2 IO may be faulty. Replaceit with a new one following the stepsdescribedin
Chapter4. If IO Boardreplacedisstill not functioning properly, perform
Check3.
Check3 SystemBoard may be defective. Replace SystemBoard with a new one
following the stepsdescribedin Chapter 4.
IO Board
System Board