dynabook Satellite Pro L50-G - Finger Print; Procedure 1 Windows Application; Procedure 1 Windows Applica�On Test; Procedure 2 Connector Check and Replacement Check

2 Troubleshooting 2.21 Finger Print
2-30 SatellitePro L50-G / dynabookP*-C* MaintenanceManual
2.21 Finger Print
            
    
    
   
Procedure 1 Windows Application
         
          
          
Procedure 2 Connector Check and Replacement Check
                
           
Disassemblethe computer following the stepsdescribed in Chapter 4 andperform the
following checks:
Check1 The SecurePadmay be faulty. Replaceit with a new one following the
instructions in Chapter 4. Then gothrough procedure 1 again. If the Finger
Print is still not functioning properly, perform Check2.
Check2 The systemboard may be defective. Replacethe systemboard with a new one
following the stepsdescribedin Chapter 4. Then gothrough procedure 1
again.