12000 Portland Avenue South, Burnsville, MN 55337, USA Europe, Africa, and Middle East only. For customer orders, contact Customer Service at:
Phone: +1 952/844-4051, Fax: +1 952/884-0043 +49 9421-706 0 Fax: +49 9421-706 265
Asia & Pacific only. For customer orders, contact Customer Service at:
www.dynacord.com +65 6571 2534 Fax: +65 6571 2699
For technical assistance, contact Technical Support at: +49 9421-706 0
© Bosch Communications Systems 09/2010
Part Number F01U164570 Vs 01 Specifications subject to change without notice.
CAUTION: Eyebolts must be fully seated and orient in the plane of pull as shown. Always use washers
under the eyebolt to distribute the load on the enclosure.
Illustration 9: C 25.2 vertically
suspended (CORRECT)
Illustration 10: C 25.2 vertically
suspended (INCORRECT)
WARNING:
Suspension
points are to
be used for a
single enclo-
sure only, never arrays.
Never exceed the limita-
tions or maximum recom-
mended working load for
the C 25.2 systems.
Illustration 11: Vertical orientation Illustration 12: Horizontal orientation
To Previous Page
Loading...
