Dynacraft 8803-92 User Manual

15
1. Gently turn the ride-on body upside down.
2. Remove the M6 locknuts and the M6 x 25 bolts with a phillips screwdriver.
3. Remove the M10 locknut with an adjustable wrench.
4. Remove the old wheel, and replace it with a new one.
5. Remount and tighten the M10 locknut, M6 locknuts and M6 x 25 bolts to secure
the new wheel.
Rear Wheel
HOW TO REPLACE THE REAR WHEEL
HOW TO REPLACE THE BATTERY
1. Gently turn the ride-on body upside down, and unzip the zipper which located at
the bottom of the body.
2. Unplug the power connector (which is connected to the battery connector).
3. Use a screwdriver to remove the two screws from the battery retainer.
4. Carefully lift the dead battery and replace it with a new one.
5. Replace the battery retainer and secure it with the screws. Plug the power
connector with the battery connector, and zip up the zipper.
Zipper
Zipper
Battery
Battery Retainer
M6 Locknut
Battery
Connector
Power
Connector
M6 X 25 Bolt
M6 Locknut
M10
Locknut
Rear Wheel

Dynacraft 8803-92 Specifications

General

Brand	Dynacraft
Model	8803-92
Category	Toy
Language	English