9
1. INSTALL BATTERIES
UNDER SEAT
• Lift the seat by hand.
• Unscrew the screw on the
batteries cover with a screwdriver
and remove the cover.
• Insert 4 x 1.5V size AA AM3 or LR6
batteries as shown, and replace
the batteries cover, securing it with
the screw removed in the first step.
• Close seat.
NOTE: Batteries not included.
Seat
Battery
Cover
M3.5 x 10mm
Round Head Screw
1.5V AA / LR6
1.5V AA / LR6
1.5V AA / LR6
1.5V AA / LR6
1.5V AA / LR6
1.5V
A
A
/ LR
6
TOOLS REQUIRED:
ASSEMBLY
Your new ride-on toy has already been assembled at the factory, but there are a
couple of things you need to do before you get started.
WARNING: THE RIDE-ON TOY IS TO BE ONLY BY AN ADULT. As shipped in the box,
it is partially assembled and in that state contains sharp edges and points on screws that
are potentially hazardous to young children. An adult should assemble the ride-on without
any help from children. Do not let children use the ride-on until assembly is complete.
Phillips Screwdriver
(not included)
D
To Next Page
Loading...
