,QVWDOODWLRQ
13
,QVWDOODWLRQ
*HQHUDO
Installation of a DX Power Module and basic DX system normally comprises:
1. Mounting the PM.
2. PM Connection with the DX System.
3. PM Connection with Motors and Park Brakes.
4. PM Connection with Batteries.
5. Pre-testing.
6. Programming and re-testing
Compatibility with Power Wheelchairs
The model DX Series power wheelchair controller will function on those
wheelchairs equipped with the following specifications:
C Motor resistance from 0 to 0.5 ohms;
C Motor voltage from 20V to 30V;
C Batteries greater than 20Ah lead acid;
C Peak motor current 60A - 80A maximum per motor output
(model dependant);
C 12V or 24V Park Brake;
(Note: 12V motors can be used if the controller is programmed to half speed).
To Next Page
Loading...