EasyManua.ls Logo

Dynamic DX Power Module PMB - Page 32

Dynamic DX Power Module PMB
85 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
,QVWDOODWLRQ
27
30&RQQHFWLRQZLWK%DWWHULHV
The Battery connector has two terminals each for battery + and battery -. Both
Battery + terminals and both Battery - terminals must be used.
Note : The final connection to the Battery + terminals should not be made until
the wheelchair is completely wired and ready for testing as described in the Testing
section.
%DWWHU\&RQQHFWRU
'\QDPLF3DUW 'HVFULSWLRQ 4W\
DXLOOM-PM Power Module Connector Kit 1
GSM60180 DX Battery Connector Kit 1
GSM61190 DX Battery Loom 1
GCN0788 DX Battery Connector Cover 1
The type of cable used must be appropriate for the environmental and mechanical
abuse it is likely to encounter. The four conductors should be sheathed, and the
junction of the wires to the plug should have strain relief.