Dynamic DX Power Module PMB - Page 42

3URJUDPPLQJ
37
3URJUDPPLQJ7RROV
Two programming tools are available, the Wizard and the DX HHP.
'\QDPLF:L]DUG
The Wizard is a PC based tool suited to programming production runs of identical
wheelchairs or modules, or one-off highly customised wheelchairs. The Wizard is
available in several versions :
OEM Generally used by the wheelchair manufacturer. Able to
program a wide range of parameters.
DEALER Similar in function to the above, but with a reduced range of
programmable options. This ensures that options that the
manufacturer wishes to keep control of cannot be disturbed.
Parameters that may cause hazards or require special expertise
to set, are not available for adjustment.
ENHANCED As Dealer above, but with the ability to edit parameters that
DEALER relate to wheelchair accessories (e.g. actuators)
FACTORY Can only replace Standard or Custom Wheelchair Programs.
No editing or diagnostics available.
Warning : The Wizard is a very powerful tool and as such requires well trained
operators and a disciplined approach to usage and distribution.
It is up to the wheelchair manufacturer to determine whether they will allow
distribution of Wizards to dealers. Refer to the Wizard Manual for further details.