Dynaphos Starter SK-200 - Page 2

Thank you for choosing DYNAPHOS studio lighng equipment! Before you proceed further, please read the
instrucon manual.
Use of this product requires basic photographic knowledge and habits.
Aenon! Please, follow the savety instrucons!
• Starter lighng equipment is designed for photo amateurs and it’s not suitable for professional work, as
also as any kind of intensive use!
• Keep out of reach of children!
• Make sure that the power outlet you plug the ash is working correctly.
• Do not disassemble or modify! There are high-voltage components inside the unit. Repairs should only be
performed by authorised service personnel!
• Do not touch the lamp cap when the ash or modeling lamp is working due to risk of burns or elecc shock!
• Disconnect the ash from the power supply when mounng accessories on or o or when you’re cleaning
the ash unit.
• Durint operaon, some of the light control accessories may be heated to high tempetures! Wait to cool
down before you mount them o.
• During operaon, do not cover the ash! Make sure that the ash unit will not be acvated in the vicinity
of inammable gases or liquids. Risk of explosions!
• Do not expose the ash unit to water drops and splashes!
• In every 30 connuous ashes at full power, leave the ash to cool down for about 3 minutes. Overheang
will occur if it is used connuously without cooling down.
• Do not ash directly into eyes from a close distance! Direct ashing into the eyes of person or animals can
cause damage to the rena and severe disrupon of the vision – up to and including permanent blindness!
• If the housing has been damaged in such a way that internal components are exposed, the ash unit may no
longer be used. Disconnect from the power supply! Do not touch any internal components. HIGH VOLTAGE!
• Use only light controlling accessories autorized by DYNAPHOS Ltd.
Savety
1