PRE-ASSEMBLY ADJUSTING THE LEG EXTENSIONS
Read the following instructions before attempting
usage. If the directions are not clear, contact a
healthcare professional or technician.
To achieve the proper adjustments and usage
of the walker, consult with a therapist or other
medical professional.
1. Adjust leg extensions by depressing the snap button
through the appropriate extension and allowing it to
snap through the appropraite hole on the walker leg
frame.
NOTE: Make certain the snap buttons are fully
engaged into the adjustment hole of each leg frame
and are at the same height before using.
2. Repeat this procedure for each of the leg extensions.
WARNINGS
• Do not exceed the maximum user weight capacity
marked on the product.
• Use for stability and assistance while walking; do not
use to support full body weight.
• Make sure all snap buttons protrude all the way
through the holes.
• All leg extensions must be set at the same height.
Before using, double check that walker has been fully
opened and is level to the floor or ground.
• The walker is not designed to hold items. Hanging
objects on the walker could tip it over, potentially
causing personal injury or damage.
• Periodically inspect rubber tips for wear and tear. If
tips are damaged, replace them immediately.
OPENING / FOLDING THE WALKER
1. Grasp the Top Hand Grip of the walker. With other
hand, push the Pivot Lock Handle down towards the
Cross Brace.
NOTE: The Pivot Lock Handle MUST be directly on
top of the Cross Brace.
2. Reverse step 1 to close the walker.
CLOSE
Top Hand Grip
Pivot Lock Handle
Cross Brace
OPEN
Snap Button
Adjustment Holes
Leg Extension
To Previous Page
Loading...
Need help?
General
