LOWER
TUBE
MIDDLE
TUBE
PULL
UPPER
TUBE
CONNECTION
CLIP
LOWER
TUBE
MIDDLE
TUBE
UPPER
TUBE
PULL
CONNECTION
CLIP
Unpack the unit, and place it on the ground. Pull the cord tight through the
middle tube and connect to upper tube. Make sure connection clip is secure
before proceeding.
Place dynatrap in upright position and connect to electrical outlet
and turn power switch “on” to operate.
Insert base connector post through bottom of stand base. Align connector
post with notch in base and connect to pole. Rotate pole nut until secure.
Pull the cord tight through the lower tube and connect to middle tube.
Make sure connection clip is secure before proceeding.
BASE
CONNECTOR
POST
BASE
POLE
NUT
ASSEMBLY INSTRUCTIONS
For Additional Information Visit www.DynaTrap.com
A000-316.2021.2
1 2
TWIST
TIGHTEN
4
GROUND
3
ENGLISH
ENGLISH
To Next Page
Need help?
General
