Dynojet POD-300 - Installing the POD-300; Mounting and Connection

2 POD-300 INSTALLATION GUIDE
IPOD-300
OVERVIEW
INSTALLING THE POD-300
1 Secure the POD-300 to the vehicle using the supplied
Velcro or suitable mount
. Make sure the POD-300 will not
interfere with the operation and steering of the vehicle.
Visit
www.dynojet.com for an array of mounting solutions
for your POD-300.
The mounting holes on the back of the module use the
standard AMP style pattern.
2 Attach the supplied cable to the port on the side of the
POD-300 and run the other end of the cable to an open
CAN port of the PCV/6 network.
Note: This can connect to the PCV, PC6, Ignition
Module, or SFM; whichever has an open CAN port. If
your network currently has a CAN termination plug
occupying the open port, you can remove the CAN
termination plug; the plug will no longer be necessary.
4 pin connection cable
•Enter Main Menu
•Scroll through menu options
To move up continue to last
selection
•Start/Stop logging
•Enter selection
•Scroll through the four gauge
screens
•Back to previous screen
Programmable warning lights
USB port
8 pin port
Not used for this application
Optional mount shown - part #61300062