service manual
Issued 10/06
9
Fitting notes
Motor replacement - fitting
Align the three locators on the motor mount
with the relevant holes in the top of the motor.
Firmly press the motor mount onto the motor.
18
Press the motor inlet seal onto the base of the
motor ensuring that all edges of the seal are in full
contact with the motor.
17
Unclip both wires from the motor.
15
Remove the motor mount and motor inlet
seal from the motor.
16
Attach the wires to the terminals on the
motor (brown wire to the terminal with the white
internal wire).
19
To Next Page
Loading...
