Dyson DC18 - Page 15

service manual
Issued 10/06
12
Fitting notes
Firmly pull the outer wheel hubs off either
side of the yoke assembly.
31
Undo one of the e-clips from the end of the
barrel wheel axle.
32
Slide the barrel wheel axle out of the yoke
assembly. Remove the barrel wheel assembly.
33
Remove the internal hose assembly from
the yoke assembly.
36
Remove the yoke assembly and internal hose
off the undercarriage assembly ensuring no
damage is caused to the coiled cable assembly.
35
Firmly pull the internal hose off the
undercarriage assembly.
34