5 www.e-bikes.se
II、General Assembly Instructions for 98% packing
1, Packaging – Remove packaging materials. Best to cut out sides of carton and remove bicycle. Remove all materials and set parts aside for
assembly.
Minimal assembly is required for a foldable bicycle. However please follow the guidelines below for correct assembly.
2, Tools required -8 mm ring spanner, 10 mm ring spanner, 15mm pedal spanner, 14 mm open end spanner, 5 mm hex key, 6 mm hex key,
screw driver, Cutters/Pliers
3, Assembly.
Set Up.
•Remove all packaging materials from the bike.
FOR 26 bike
Alignment of handle bars
•The handle bar assembly may need some small adjustment for the alignment of the headset to the front wheel.
•Use a 5 mm Hex key to loosen the handle bar stem.
To Next Page
Loading...