E-Mu 1212M - Rear Panel Connections

14 - E-MU PCI Digital Audio System
Rear Panel Connections
Line Level
Analog Inputs
Four balanced 24-bit, line-level, analog inputs are provided (Stereo 1-2). These can be used to
input any line level signal such as a keyboard, CD-player, cassette deck, etc. (The analog inputs are
assigned to mixer strips in the PatchMix DSP mixer application.) Input line level can be set to
accommodate the consumer -10dBV standard, or the pro audio +4 dBu standard in the I/O screen
of the Session Settings dialog box.
Either TRS balanced or TS unbalanced cables can be used. Balanced cables provide better noise
immunity and +6dB higher signal level, but standard mono instrument cables also work well.
EDI
In
1L
1R
2L
2R
3L
3R
2L
2R
Out
1L
1R
Phono
Gnd
2L
2R
1
2
Out
48
VDC
+
-
MIDI Cable
3
4 Balanced Line Level Inputs
(configured as 2 stereo pairs)
Turntable Inputs
(tied to line input 2)
Turntable
Ground
Alternate Outputs6 Balanced Line Level Outputs
(configured as 3 stereo pairs)
MIDI Port
Connector
48 Volt DC
Power Inpu
t
Connect to
1010 PCI Card
(same as outputs 1-3)
EMU QS(En).fm Page 14 Thursday, October 26, 2006 11:09 AM