Quick Start Guide - Getting Started - 5
Step 5: Connecting the MicroDock to the E-MU 1010 Card
Connect the supplied network-type cable from the RJ-45 jack on the E-MU 1010 PCI card labeled “EDI” to the matching
connector labeled “EDI” on the MicroDock. The cable type is a standard CAT 5e network cable which is specially shielded to
prevent RF emissions. Contact E-MU Systems if you need a replacement cable.
CAUTION:
Do not connect the supplied
CAT 5e
cable to the Ethernet or network connector on your computer. Doing
so may result in permanent damage to either your computer, the E-MU 1010 or both.
Supplying Power to the MicroDock
The MicroDock is powered from the supplied +48VDC Adapter. Connect the Adapter to the jack marked +48VDC on the
back panel of the MicroDock. Turn the MicroDock on by turning the Headphone Volume control up.
EDI
48
VDC
+
-
+48V DC Adapter
1010 PCI Card
The Headphone
Volume Control is
also the Power Switch.
EMU QS(En).fm Page 5 Thursday, October 26, 2006 11:09 AM
To Next Page
Loading...
