6 - E-MU Digital Audio System
Connecting the AudioDock to the E-MU 1010 Card
Connect the supplied network-type cable from the RJ-45 jack on the E-MU 1010 PCI card labeled “EXTERNAL” to the
matching connector labeled “CARD” on the AudioDock.
The cable type is a standard CAT 5e network cable which is specially shielded to prevent RF emissions. Contact E-MU
Systems if you need a replacement cable.
CAUTION:
Do not connect the supplied
CAT 5e
cable to the Ethernet or network connector on your computer. Doing
so may result in permanent damage to either your computer, the E-MU 1010 or both.
To Next Page
Loading...
