E-Mu 1212M - Rubber Feet; Rack Mounting the Audiodock

2 - Installation
Install the Sync Daughter Card or 0202 Daughter Card
16 Creative Professional
Rubber Feet
Four rubber feet were included with the AudioDock. These feet should be used if you’re
not going to rack mount the AudioDock. If you are going to rack mount the AudioDock,
leave the feet off.
To install the rubber feet, simply peel off the protective backing from the adhesive and
press the feet into the round depressions at each corner of the bottom plate.
Rack Mounting the AudioDock
The AudioDock was designed to be rack mounted using standard 19-inch rack shelves.
( These shelves are available from a number of sources on the Internet. Search for “Rack Shelf”.)
Two AudioDocks fit side by side on a single rack shelf. Two screws are provided to secure
the AudioDock to the rack shelf (M3 x 6mm). Do not use screws longer than 6mm or
damage to the circuit board may result.
Rubber
Foot
Rack-shelf
mount
Rack-shelf
mount
Rack-shel
f
mount
Rack-shel
f
mount
Rubber
Foot
Rubber
Foot
Rubber
Foot