Emax II operation manual
89
Press YES if you want to copy the Sustain Loop parameters to the Release Loop and then
return to the module identifier, or NO if you want to set different parameters for the
Sustain and Release Loops.
2. If you pressed NO, the display shows:
Lp:Start Length
XXXXXXX XXXXXXX
The seven digits under Start indicate, in number of sample points, the Start of the Loop
in relation to the beginning of the voice. A higher number moves the Start point closer
to the end of the sample. The seven digits under Length indicate the Loop Length in
number of sample points. A higher number increases the loop Length. Select the
parameter to adjust with the cursor buttons. Adjust the coarse value with the data slider
and fine value with the increment and decrement keys, or enter a six-digit number.
3. Remember—L sets the Length, not the end point, of the loop. When S moves, the loop
end point (as determined by the loop Length) moves in tandem with S.
After finding a good loop, press ENTER.
This loop plays
for as long as the
envelope is in the
sustain phase.
Release
Loop Start
Release
Loop
Length
Sustain
Loop
Length
Sustain
Loop
Start
This loop plays for as
long as the release phase
of the envelope lasts.
As the release fades out,
the looped sound will fade
out as well.
The Release Loop begins as soon as the key is released and continues until the sound fades
out.
DIGITAL PROCESSING
Release Loop
To Next Page
Loading...