Emax II operation manual
92
DIGITAL PROCESSING 5 TAPER
This adds a fade-in and/or fade-out to the sample, thus smoothing out samples
with abrupt beginnings or endings.
You will not hear the effects of tapering until the Enter button is pressed. Always
make sure you have a backup of anything that you taper in case the taper does not
turn out well.
1. Activate DIGITAL PROCESSING 5. The display shows:
Taper Start End
00ms 000ms
2. Start taper (fade-in) ranges from 00 milliseconds (ms) to 99 ms. End taper (fade-out)
ranges from 000 ms to 999 ms. Use the arrow keys to position the cursor under the
parameter to be adjusted. Set the value with the data slider .
3. After setting the desired taper point, press ENTER. The display will say “Tapering...”
When tapering is complete, the Emax II will return to the module identifier and your
voice will be tapered.
Taper Start Taper End
Before Tapering
After Tapering
DIGITAL PROCESSING
Taper
To Next Page
Loading...