Emax II operation manual
94
3. The display says:
Select Voice
Play A Key
Play a note within the range of the desired voice, then press ENTER. The sample used
by this voice will be spliced after the sample used by the first voice.
4. The display shows:
Splice
EXXXXXX SYYYYYY
...where XXXXXX is the initial End point of the first sample and YYYYYY is the initial
Start point of the second sample.
5. The six digits following the E indicate, in samples, the first sample’s End point. Adjust
the coarse value with the data slider and fine value with the increment and decrement
keys, or type in a six- digit number with the keypad. Example: At the nominal sampling
rate, E028000 means that the end point is located one second into the first sample. The
keyboard will be inactive and you will not hear anything if you play it.
6. The six digits following the S indicate, in samples, the second voice’s Start point.
Adjust the coarse value with the data slider and fine value with the increment and
decrement keys, or type in a six-digit number. Example: A reading of S028000 means that
the Start point is one second into the second voice. When the splice points are correct,
press ENTER.
7. The display now says:
Crossfade Time:
000ms
Use the slider to specify a crossfade time, in 10 ms increments, between 000 and 990 ms.
Crossfade provides a smooth transition between the sounds at the splice point. When
set as desired, press ENTER.
DIGITAL PROCESSING
Splice
To Next Page
Loading...