Emax II operation manual
100
... where XXXXX can be any sample rate from 7000 Hz to 50000 Hz and YYYYY can be
any Emax II sample rate (20.0 kHz, 22.050kHz, 27.778kHz, 31.250kHz, 39.0625kHz)
2. When the sample rates have been selected, press ENTER and the display warns:
Modifies Sample&
Takes XX min.OK?
... XX being the time it take the Emax II to do the calculations for the conversion.
3. Press YES to convert, NO to return to the module identifier.
Note: The rates given in the NewRate column are the actual Emax II sample rates. The
sample rates shown in the sample module are approximations. When doing sample rate
conversions to conserve memory, be sure to use the actual Emax II rates in the OldRate
column.
Sample Rate Conversion requires memory space to perform its calculations. In some
cases there may not be enough memory left to convert the sound, in which case the
display warns you.
■
4 Change Pitch
Allows you to digitally change the pitch of a sound.
Application: Change the pitch of a sound in order to splice or combine it with another
sound of a different pitch.
1. Select DIGITAL EFFECTS 4 and the display will say:
Change Pitch
+00.00 semitones
The Pitch Change range is ±35 semitones, 99 cents. Use the cursor keys to select between
semitones and cents.
2. When the amount of pitch change has been selected, press ENTER and the display
warns:
DIGITAL PROCESSING
Change Pitch
▼
Make sure to
change the pitch of
both sides of a stereo
voice to prevent unde-
sirable results.
To Next Page
Loading...