Emax II operation manual
107
PRESET MANAGEMENT
PRESET MANAGEMENT 1 LOAD PRESET
Use this to load an individual preset from disk into the Emax II memory bank.
1. Insert the disk containing the preset to be loaded into the disk drive.
2. Activate PRESET MANAGEMENT 1. The display says:
Load PXX
Select A Preset
3. Use the data slider or the increment/decrement buttons to select the source bank
(either from hard disk or floppy), then press ENTER. The display now says:
Load PXX
Select A Preset
...where XX is the number of the preset to be loaded (source preset). Use the data slider
to catalog the presets available for loading, as displayed on the lower line. When you find
the desired preset, press ENTER.
4. The display now says:
Load PXX To PYY
Select A Preset
...where XX is the number of the source preset and YY the number of the destination
preset (this defaults to the first empty preset). Select the desired destination preset (use
the data slider or numeric keypad) and press ENTER. If the preset is not empty, a
message will appear asking if you want to overwrite the existing preset.
5. If the load was successful, the display will give you the chance to rename the preset.
Name the preset as described in PRESET MANAGEMENT 6 and then press ENTER to
return to the module identifier.
Note: If you load a preset that uses samples already present in the bank, new copies of
the samples will not be loaded. This technique saves a great deal of memory space.
Load Preset
To Next Page
Loading...