Emax II operation manual
112
PRESET MANAGEMENT 8 SAVE ALL 16 BIT
This function saves the entire Emax II bank to disk in 16-bit linear format.
1. Use the DRIVE SELECT function to select the destination disk drive.
2. Activate PRESET MANAGEMENT 8.
FLOPPY DISK
If you are saving to floppy disk, the display says:
Save All 16 Bit
to X disks? Y/N
... where X is the number of floppy disks required to save the bank.
3. To save the preset, press YES, or press NO to return to the module identifier.
HARD DISK
If you are saving to a hard disk, the display says:
Save Bank to
BXX Name of Bank
... where X X is the bank number and “Name of Bank” is the name of the current preset
at the time that the bank was saved.
4. Use the data slider to select the destination bank on the hard disk , then press ENTER.
PRESET MANAGEMENT
Save All 16 Bit
To Next Page
Loading...